Table of Contents
Advertisement
Input
1. Set the channel selector to USB.
2. Connect the PC or Mac to the USB port with a standard high-speed USB cable
(not supplied). Then play the audio through the computer's audio player.
Record
1. On the mixer, mix your inputs.
2. Connect the PC or Mac to the USB port with a standard high-speed USB cable
(not supplied). Record the audio to the PC or Mac.
Additional Information
Replacing the Fuse
Your mixer requires a 250 Volt, 0.5 Amp fuse to protect it from power surges
and short circuits. If the mixer suddenly turns off or will not turn on, the fuse
could be blown. Replace the fuse with a 250 Volt, 0.5 Amp, fast-blow, 1¼ x ¼
inch (32 mm x 6.35 mm) fuse (not supplied, available at your local RadioShack
store or at www.radioshack.com).
n
Note: Do not use a fuse with a rating other than that specified here. Doing
so might damage your mixer.
1. Unplug the mixer from the AC outlet.
2. Use a Phillips screwdriver to remove the fuse compartment cap from the mixer.
3. Remove the old fuse and replace it with an identical fuse.
4. Replace the fuse compartment cap.
Fuse Compartment
Cap
Service and Repair
If your mixer is not performing as it should, take it to your local RadioShack
store for assistance. Modifying or tampering with the mixer's internal
components can cause a malfunction and might invalidate its warranty.
21
Hide quick links:
Advertisement
Table of Contents
