Installation; Water Connection - Zanussi ZDF4010 User Manual

Warning! To discard the appliance, follow the
procedure:
• Pull the mains plug out of the socket.
• Cut off the mains cable and mains plug and discard
them.

Installation

Warning! Make sure that mains plug is
disconnected from the mains socket during
installation.
Fitting under a counter
Put the appliance adjacent to a water tap and a water
drain. Remove the appliance worktop to install it under
a sink unit or a kitchen worktop. Make sure that the di-
mensions of the recess agree with the given dimensions.
1

Water connection

Water inlet hose
Connected the appliance to a hot (max. 60°) or cold wa-
ter supply.
If the hot water comes from alternative sources of ener-
gy that are more environmentally friendly (e.g. solar or
photovoltaic panels and aeolian), use a hot water sup-
ply to decrease energy consumption.
Connect the inlet hose to a water tap with an external
thread of 3/4".
Caution! Do not use connection hoses from an
old appliance.
The water pressure must be in the limits (refer to the
chapter 'Technical data'). Make sure that the local water
authority gives you the average mains pressure in your
area.
16
2
• Discard the door catch. This prevents the children to
close themselves inside the appliance and endanger
their lives.
3
Install the appliance worktop to the appliance if you
want to use the dishwasher as a freestanding appliance.
The plinth on freestanding appliance is not adjustable.
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal
the door correctly. If the level of the appliance is cor-
rect, the door does not catch on the sides of the cabinet.
If the door does not close correctly, loosen or tighten
the adjustable feet until the appliance is level.
Make sure that there are no kinks in the water inlet hose
and that the water inlet hose is not squashed or entangled.
Turn the inlet hose to the left or the right to suit the in-
stallation. Fit the locknut correctly to prevent water leaks.
Caution! Do not connect the appliance to new
pipes or pipes that are not used for a long time.
Let the water run for some minutes, then connect the
inlet hose.
4