Using System Functions From Outside (Disa: Direct Inward System Access) - Siemens HiPath 2000 Operating Instructions Manual

Step by Step
Using system functions from outside
(DISA: Direct Inward System Access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0
• Call forwarding, code
• Lock and unlock phone,
code 66/#66
*
• Save your PIN,
code 93
*
• Send a message,
code 68/#68
*
• Leave an advisory message,
code 69/#69
*
• Ringing group, code
• Group call, code
• Caller ID suppression,
code 86/#86
*
• Camp-on tone, code
• Open door, code
• Release door opener, code
• Control relays, code
• Do not disturb, code
• Ringer cutoff, code
• Dial using speed dial, code
• Associated service, code
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j
Establish a connection to the system. Enter the station
number (contact your service personnel).
j
Wait for the continuous tone (if necessary, switch
phone to tone dialing) and enter the internal number as-
signed to you and the corresponding PIN.
(
Enter the code (only required if programmed in the sys-
tem).
More functions/services
page 71
1/#1
*
page 63
page 65
page 67
page 69
81/#81
*
85/#85 page 79
*
page 60
87/#87
*
61 page 36
*
89/#89
*
90/#90
*
97/#97
*
98/#98
*
7
*
83
*
page 28
page 79
page 48
page 37
page 77
page 59
page 59
page 43
page 72
73