Electrical Connection - Dishlex DX 301 User Manual

The water pressure must be in the limits (refer to 'Tech-
nical data'). Make sure that the local water authority
gives you the average mains pressure in your area.
Make sure that there are no kinks in the water inlet hose
and that the water inlet hose is not squashed or entan-
gled.
Fit the hose nut correctly to prevent water leaks.
Caution! Do not connect the appliance to new
pipes or pipes that have been not used for a long
time. Let the water run for some minutes, then connect
the inlet hose.
Water drain hose
The highest point of the drain hose must be no more
than 60 cm from the floor and must have a continuous
fall.
The drain hose can be lengthened using additional
lengths and connectors. These must be purchased
from Electrolux Spare Parts. The extension length must
not exceed 2 metres.
The drain hose must be free of kinks and obstructions.
Remove the sink plug when the appliance drains the
water to prevent that the water goes back into the ap-
pliance.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane. If you do
not remove the membrane, remaining food can cause
a blockage in the drain hose spigot.

Electrical connection

Warning! Safety standards require the appliance
to be earthed.
Prior to using the appliance for the first time, ensure
that the rated voltage and type of supply on the rating
plate match that of the supply where the appliance is
to be installed.
The fuse rating is also to be found on the rating plate.
The appliance has a security feature to prevent dirty
water going back into the appliance. If, the spigot of the
sink has a 'non-return valve', this valve can cause the
appliance to drain incorrectly. Remove the non-return
valve.
Make sure that the water couplings are tight to prevent
water leakage.
Caution! Ensure that hoses are not crushed or
kinked under or behind the appliance.
Caution! Once connected the inlet hose to the
water tap, turn the tap on and check that there
are no leaks.
17