Contents Safety information Daily use Safety instructions Hints and tips Control panel Care and cleaning Programs Troubleshooting Settings Technical information Before first use Warranty Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
If the supply cord is damaged, it must be replaced by the manufacturer, its • Authorised Service Centre or a similarly qualified persons in order to avoid a hazard. Put knives and cutlery with sharp points in the cutlery basket with the •...
• The appliance can release hot steam if you open the door while a programme operates. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Service • Contact the Authorised Service Centre to repair the appliance.
Indicators Indicator Description End indicator. Multitab indicator. Rinse aid indicator. It is always off while the program operates. Programs Program Degree of soil Program phases Consumption values Type of load Duration Energy Water (min) (kWh) Normal soil • Prewash 0.75 11.6 •...
Settings Program selection mode The appliance is in Program selection mode when all the program indicators come on and the display shows 2 horizontal status bars. When the appliance is in Program selection mode it is possible to set a program. If the control panel does not show this condition, use the Reset function.
1. Make sure that the appliance is in Program selection mode. 2. Press and hold at the same time until the indicators start to flash. 3. Press go off. continues to flash. The display shows the current setting of the rinse aid dispenser. •...
Page 8
Adding detergent If the program has a prewash phase, put a small quantity of detergent also in compartment B. Adding multi-tablets The Auto Off function This function decreases energy consumption by deactivating automatically the appliance when it is not operating. The function comes into operation: •...
Page 9
1. Press the on/off button to activate the appliance. Make sure that the appliance is in program selection mode. 2. Press the button related to the program you want to start. • The related program indicator starts to flash. • The display shows the program duration.
At the end of the program 5 min Press the on/off button to deactivate the appliance. If you don't press the on/off button, the Auto Off function automatically deactivates the appliance a few minutes after the end of the program. Hints and tips General •...
• Remove remaining food from the items. • The position of the items in the baskets is correct. • Make soft the remaining burned food on the items. • The programme is applicable for the type of load • Put hollow items (cups, glasses and pans) with the and for the degree of soil.
Cleaning the spray arms Internal cleaning Do not remove the spray arms. If the holes in the spray • Carefully clean the appliance, including the rubber arms are clogged, remove remaining parts of soil with a gasket of the door, with a soft moist cloth. thin pointed object.
The washing and drying results are not satisfactory Problem Possible solution • The release quantity of rinse aid is too much. Adjust the rinse aid selec- There are whitish streaks or bluish lay- tor to a lower position. ers on glasses and dishes. •...
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND replace any parts which it considers to be defective. Electrolux or its ASC may use APPLIANCE: DISHWASHER remanufactured parts to repair your Appliance. You This document sets out the terms and conditions of agree that any replaced Appliances or parts the product warranties for Electrolux Appliances.
Page 15
was purchased in New Zealand for commercial 11. At all times during the Warranty Period, Electrolux purposes the Consumer Guarantee Act does not shall, at its discretion, determine whether repair, apply. replacement or refund will apply if an Appliance has 9.