Sony MDS-JB920 Service Manual page 20

5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
(1) Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
[ AMS ]
±
(2) Rotate the ≠
[YES]
(3) Press the button to change the display to "CPLAY MID".
(4) When access completes, the display changes to "C =
Note: The numbers " " displayed show you error rates and ADER.
2. Changing the parts to be played back
[YES]
(1) Press the button during continuous playback to change the display as below.
"CPLAY MID" n "CPLAY OUT" n "CPLAY IN"
When pressed another time, the parts to be played back can be moved.
(2) When access completes, the display changes to "C =
Note: The numbers " " displayed show you error rates and ADER.
3. Ending the continuous playback mode
[MENU/NO]
(1) Press the button. The display will change to "CPLAY MODE".
[ EJECT]
§
(2) Press the button to remove the disc.
Note: The playback start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
(1) Set a recordable disc in the unit.
[ AMS ]
≠ ±
(2) Rotate the
[YES]
(3) Press the button to change the display to "CREC MID" (C31).
(4) When access completes, the display changes to "CREC (
Note: The numbers " " displayed shows you the recording position addresses.
2. Changing the parts to be recorded
[YES]
(1) When the button is pressed during continuous recording, the display changes as below.
"CPLAY MID" n "CPLAY OUT" n "CPLAY IN"
When pressed another time, the parts to be recorded can be changed.
(2) When access completes, the display changes to "CREC (
Note: The numbers " " displayed shows you the recording position addresses.
3. Ending the continuous recording mode
[MENU/NO]
(1) Press the button. The display changes to "CREC MODE" and
[ EJECT]
§
(2) Press the button to remove the disc.
Note 1: The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
[MENU/NO]
Note 2: The
Note 3: Do not perform continuous recording for long periods of time above 5 minutes.
Note 4: During continuous recording, be careful not to apply vibration.
5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the
knob and display "CPLAY MODE" (C30).
knob and display "CREC MODE".
button can be used to stop recording anytime.
[MENU/NO]
AD = ".
AD = ".
REC
" and lights up.
REC
goes off.
REC
" and lights up.
REC goes off.
button immediately to exit it.
– 20 –