Sound Is Interrupted Or Noise Occurs - Denon AVR-X500 Owner's Manual

Contents
Symptom
Dolby TrueHD, DTS-HD, Dolby Digital
Plus audio is not output.
Dolby PLg mode or DTS NEO:6 mode
cannot be selected.
"RESTORER" cannot be selected.

2 Sound is interrupted or noise occurs

Symptom
Noise often occurs in FM/AM
broadcasting.
Front panel Display
Connections Playback
• Make HDMI connections.
• Check the digital audio output setting on the connected device. On some devices, "PCM" is
set by default.
• It cannot be selected when "None" is set for "Speaker Config." – "Center" and "Surround".
• These cannot be selected when using the headphones.
• Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback
of multichannel signals such as Dolby Digital or DTS surround, "Restorer" cannot be used.
• Switch the surround mode to other than "DIRECT".
• Change the antenna orientation or position.
• Separate the AM loop antenna from the unit.
• Use an FM outdoor antenna.
• Separate the antenna from other connection cables.
Rear panel
Settings
Cause / Solution
Cause / Solution
78
Remote
Tips Appendix
Page
27, 28
Page
Index
–
57
–
68
43
31
31
31
31