Chiseling - Chicago Electric 69334 Owner's Manual & Safety Instructions

Chiseling

Changing Chisel Bits
1. Grease the bit shank before installing.
2. Pull back on the Chuck and insert the Bit. Make
sure it slides all the way into the opening.
3. Release the Chuck.
Chisel Operation
1. Adjust the Auxiliary Handle as needed.
2. Plug in the Power Cord.
3. Squeeze and hold the Trigger to
turn on the Rotary Hammer.
4. Allow the Rotary Hammer to reach full speed
before contacting the work surface.
Item 69334 For technical questions, please call 1-888-866-5797.
4. Rotate the Mode Selector so the Adjust
Chisel Setting is in the ON position. Rotate
the bit to the desired angle then rotate the
Mode selector to the Hammer setting.
5. Check that the bit is secured in place. It should
not be able to be pulled out of the Chuck.
5. When finished, to prevent accidents, release
the Trigger and disconnect its power supply
after use. Pull back on the Chuck then remove
the bit from the Chuck. Clean, then store
the tool indoors out of children's reach.
Page 11