Page 1
1” SDS ROTARY HAMMER Model 47606 SET up AnD OpERATing inSTRucTiOnS Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Distributed exclusively by Harbor Freight Tools ®...
Maintain tools with care. Keep tools sharp and clean for better and safer performance. Follow instructions for lubricating and changing accessories. Inspect tool cords periodically and, if REV 03d; 05k SKU 47606 For technical questions, please call 1-800-444-3353. Page 2...
Page 3
WARning: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known [to the State of California] to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: REV 07c SKU 47606 For technical questions, please call 1-800-444-3353. Page 3...
Use tools with the lowest vibration when there is a choice between different processes. Include vibration-free periods each day of work. To reduce vibration, maintain the tool as explained in this manual. If any abnormal vibration occurs, stop use immediately. REV 07j SKU 47606 For technical questions, please call 1-800-444-3353. Page 4...
Page 5
Fully tighten the Handle (505) clockwise. If you wish to reposition the Handle (505) or the Drill Stop (504), loosen the Handle (505) by turning it counterclockwise. FiguRE 1 Handle Band (508) Bit Sleeve Handle (505) Drill Stop (504) REV 07j SKU 47606 For technical questions, please call 1-800-444-3353. Page 5...
Page 6
Switch in the hammer/drill position will result in unexpected tool performance. Switch (86) Knob (701) Main Handle (89) FiguRE 3 Bit Sleeve Handle (505) Drill Stop (504) Brush Cap (70) REV 07c; 07j SKU 47606 For technical questions, please call 1-800-444-3353. Page 6...
Release the Switch, stopping the Hammer. Position the chisel or bit on the workpiece and start the Hammer again. After using the Rotary Hammer, release the Switch to turn off the unit. REV 03d, 07c SKU 47606 For technical questions, please call 1-800-444-3353. Page 7...
Remove the eraser dust from the brush (69) when you are through cleaning it. Gently reinstall the brush (69) into the brush Holder (68) and screw the brush cap (70) back on the unit and tighten. SKU 47606 For technical questions, please call 1-800-444-3353. Page 8...
Replacement parts with asterisk are not available individually. You must purchase either the #100 Motor Assembly or the #101 Cable Assembly. * #100 Motor only sold as a replacement assembly. ** #101 Cable only sold as a replacement assembly. SKU 47606 For technical questions, please call 1-800-444-3353. Page 9...
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 SKU 47606 For technical questions, please call 1-800-444-3353. Page 11...