Samsung SND-5011 User Manual page 16

overview
Item
Reset Button
d
Inner Cover
e
Bracket
f
Wiring Cover
g
Lock Release
h
16_ overview
Resets the camera settings to the default.
Press and hold for about 5 seconds to reboot the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Cover used to protect the main unit.
Used to install the camera on the wall or ceiling with the screws.
If installation requires drilling, run the cable through here.
To separate the bracket from the main unit for the installation or to separate
the camera from an installed camera, push this release and turn the main
unit in the marked direction of <UNLOCK>.
Description