Operation Programming/Setting Clock - Hunter 44259 Owner's Manual

B93Q book English p. 1-15 2/7/03 10:05 AM Page 16
Programming
1 Remove mylar label covering display
window.
2 When the heating or cooling system is
actually operating, "HEAT" or "COOL"
will appear on the display.
Setting the Time and Day of Week
When you first install the two AA batteries, the thermostat automatically sets the day and
time to Monday, 12:00 a.m., shows the current room temperature and is programmed for 68°
in heat mode and 78° in cool mode. Press the reset button after installing new batteries.
The first data you should enter is the current time and day of week. As the keys are pressed,
the display will show the data being entered.
EXAMPLE:
If the unit is
Initial read-out after pressing
being
reset button.
installed at
Current room temperature is 72°.
9:15 p.m.,
No indication of program number.
Saturday, to
set the
Press once. Temperature digits
thermostat,
disappear, show time set mode.
you would
HOUR
press the
keys in the
shown
sequence.
16-17
3 If power is interrupted the batteries will
keep all programs.
4 If "LOW BATT" indicator appears on the
display replace the batteries.
M T W TH F SA SU I 2 : 00 7 2 HEAT COOL
c
AM
PM
SET TEMP HOLD TEMP
FILTER LO BAT
M T W TH F SA SU I 2 : 00 HEAT COOL
7 2 c
AM
PM
FILTER LO BAT SET TEMP HOLD TEMP