Table of Contents
Advertisement
Installing and Starting the Control Program
Another way to operate the switcher, to set the skew
adjustments, the level and peaking, and the output pre-peaking
(see "Optimizing the video", beginning on page 4-18), is via
the Windows
This program is contained on the Extron Software Products
DVD (included with the switcher). Run this program on a
PC connected to a serial port (
2-6), Ethernet port (
program must be installed on a Windows-based computer and
cannot be run from the DVD.
N
Installing the program
N
1.
N
2.
3.
MTPX Plus Series • Remote Control and Optimizing the Video
Refer also to the MTPX Plus User's Manual at www.extron.com.
-based Matrix Switchers Control Program.
®
k
), or USB port (
For details on operating the program, refer to the
MTPX Plus User's Manual, chapter 5, "Matrix
Software".
To run this program while your computer is connected
to an MTPX Plus 128 Configuration (USB) port, use
version 7.7 or newer of the Matrix Switchers Control
Program.
Insert the DVD into the drive. The Extron software DVD
window should appear automatically.
If the window does not self-open, run Launch.exe from the
DVD.
The Extron software DVD window appears.
Click the Software tab.
Scroll to the Matrix Switchers program and click
Install.
i
,
j
, and
m
on pages 2-5 and
n
) on the switcher. The
4-15
Advertisement
Table of Contents
