Extron electronics MLS 306 User Manual page 25

The following flowchart shows the main menus and submenus available for all
four switcher models. Items within the dashed lines are not offered on all models.
FIRMWARE
Power
on
Ver 1.XX
2 sec.
EXTRON
MLS506SA
2 sec.
MENU
VIDEO
CONFIG
MENU
AUDIO
ADJUST
MENU
AUDIO
SETTINGS
MENU
EXIT
MENU
NEXT MENU
or timeout
Video input format
INPUT
selection/configuration is not available
#2
or necessary for the MLS 306.
Select the video type
for inputs 1–3. Select
Default: Vid. another
input.
NEXT
Input #2
<Vid>YUV
3
VOLUME
ADJUST
Input #2
Vid<YUV>
Set audio output level
per input.
MLS 306/506: -15dB to +09dB
MLS 506MA/506SA: 0 to 100 steps
NEXT NEXT
Level
#2 050
VOLUME
ADJUST
Level
#2 067
Stereo: Audio Out
outputs stereo audio.
Set the overall
Mono: the Audio Out
left / right audio
signal is the same
output balance.
on both left & right.
NEXT NEXT
Balance
––––––––
VOLUME
ADJUST
Balance
––––––––
Select Inputs 4–6
another
are RGB only.
input.
Input #3 Input #5
<Vid>YUV RGB Only
5
VOLUME
ADJUST
Input #3
Vid<YUV>
Adjust bass Adjust treble
per input (2dB per input (2dB
increments). increments).
-14dB to +14dB -14dB to +14dB
NEXT
Bass Treble
#2 +00dB #2 +00dB
VOLUME VOLUME
ADJUST ADJUST
Bass Treble
#2 -08dB #2 +06dB
MENU
The Effects submenu
is available for the
MLS 506MA and
MLS 506SA only.
Default: the Effects
Return is disabled.
Enable: the Effects
Return will be active,
its input will be sent
to the Audio Out and
amplified outputs.
NEXT
Output Effects
M<Stero> E<Dsabl>
VOLUME VOLUME
ADJUST ADJUST
Output Effects
<Mono>St <Enabl>D
MediaLink Switchers • Operation
RGB delay time:
0 seconds to 5
seconds in 0.5
sec. intervals.
NEXT
RGBdelay
0.0 sec
VOLUME
ADJUST
RGBdelay
5.0 sec
NEXT / MENU
The Speaker Load
submenu is
available for the
MLS 506SA only.
4ohm: 4 ohm load
on stereo amplified
output.
8ohm: 8 ohm load
on stereo amplified
output.
NEXT
SpkrLoad
<4ohm> 8
VOLUME
ADJUST
SpkrLoad
4 <8ohm>
NEXT / MENU
3-5