Automatic Station Preset (Fm Stations Only) - Yamaha R-S300 Owner's Manual

FM/AM TUNING
Automatic station preset
(FM stations only)
You can use the automatic station preset function to
automatically register FM stations as presets. This
function enables this unit to automatically tune in to FM
stations that have a strong signal and store up to 40 of
those stations in order. You can then easily recall any
preset station by selecting its preset number.
Notes
• If a station is registered to a preset number that already has a
station registered to it, the previously registered station is
overwritten.
• If the station you want to store is weak in signal strength, try
using the manual preset tuning method.
y
FM stations registered as presets using the automatic preset
registration feature will be heard in stereo.
B / C
ENTER
RETURN
OPTION
1
Rotate the INPUT selector on the front panel
(or press FM on the remote control) to select
TUNER as the input source.
Note
If you press FM on the remote control to select TUNER as the
input source, the corresponding band is also selected, therefore
you may skip step 2.
20
En
INPUT selector
FM
PRESET j / i
FM
PRESET j / i
2
Press FM on the front panel (or FM on the
remote control) to select FM as the reception
band.
FM is displayed on the front panel display.
3
Press OPTION on the remote control.
The Option menu for TUNER is displayed (see page
29).
4
Press B / C on the remote control to select
"Auto Preset", and then press ENTER.
This unit starts scanning the FM band about 5
seconds later from the lowest frequency upwards.
y
• Before scanning begins, you can specify the first preset number
to be used by pressing PRESET j / i on the front panel (or
PRESET j / i or B/C on the remote control).
• To cancel scanning, press FM or AM on the front panel (or FM
or AM or RETURN on the remote control).
Preset number
When presets are registered, information is displayed
on the front panel display as shown in the illustration
above.
When scanning is complete, "FINISH" is displayed
and then the display returns to the Option menu.
To return the display to the original state, press
OPTION or RETURN on the remote control.
Frequency