Honda 2006 Odyssey Owner's Manual page 279

4. Press and hold the button on
HomeLink for 3 to 4 seconds.
5. Press and hold the HomeLink
button again for 3 to 4 seconds.
This should turn off the training
indicator on the garage door
opener unit. (Some systems may
require you to press the button up
to three times.)
6. Press the HomeLink button again
for about 1 second. It should
operate the garage door.
Erasing Codes
To erase the codes stored in all three
buttons, press and hold the two
outside buttons until the red
indicator begins to flash, then
release the buttons.
You should erase all three codes
before selling the vehicle.
Retraining a Button
If you want to retrain a programmed
button for a new device, you do not
have to erase all button memory.
You can replace the existing memory
code using this procedure:
1. Press and hold the HomeLink
button to be trained until the
HomeLink indicator begins to
flash slowly.
If a rolling code transmitter was
previously programmed, the
indicator will flash rapidly for 2
seconds, and then stay on for
about 23 seconds.
HomeLink Universal Transceiver
If a standard transmitter was
programmed, the indicator will
stay on for about 25 seconds.
2. Once the HomeLink indicator
begins to flash slowly, continue to
hold the HomeLink button, and
follow steps 3 thru 6 under
''Training HomeLink'' (see page
273 ).
275