Playing a Tape
To Play a Tape
Optional on all model s except Touring
with RES and navigation system
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Make sure the open side of
the tape is facing right, then insert
the tape most of the way into the slot.
The system will pull the tape in the
rest of the way and begin to play it.
The tape direction indicator will
come on to show you which side of
the tape is playing. The
indicates
the side you inserted upward is now
playing. If you want to play the other
side, press the PLAY/PROG button.
When the player reaches the end of
the tape, it will automatically reverse
direction and play the other side.
230
Dolby noise reduction turns on
when you insert a tape. The
indicator will come on in the
display. If the tape was not recorded
in Dolby, turn it off by pressing the
NR button. Dolby remains off until
you press the NR button again.
Dolby noise reduction is manufactured under
license from Dolby Laboratories Licensing
Corporation. ''DOLBY'' and the double-D symbol
are trademarks of Dolby Laboratories
Licensing Corporation.
To Stop Playing a Tape
To remove the tape, press the
EJECT button. If you want to turn
the player off, press the PWR/VOL
knob or turn off the ignition. The
tape will remain in the drive. When
you turn the system back on, the
tape will begin playing where it left
off.
To switch to the radio or CD player
while a tape is playing, press the AM
or FM button or AM/FM button, or
CD button. To change back to the
tape player, press the AUX button.
Tape Search Functions
To rewind the tape,
FF/REW
push the REW button. You will see
REW in the display. To fast forward
the tape, push the FF button. You
will see FF displayed. Press the FF,
REW, or PLAY/PROG button to
take the system out of rewind or fast
forward.