Generator Use; Connections To A Building's Electrical System; Ground System; Special Requirements - Honda EG3500X Owner's Manual

GENERATOR USE
Connections to a Building's Electrical Sydtem
Connections for standby power to a building's electrical system must be
made by a qualified electrician. The connection must isolate the generator
power from utility power, and must comply with all applicable laws and
electrical codes.
m Improper connections to a building's electrical system
!
, -
can allow electrical current from the generator to backfeed into the
utility lines. Such backfeed may electrocute utility company workers
or others who contact the lines during aipower outage. Consult the
utility company or a qualified electrician
r-imEq Improper connections to a building's electrical system
can allow electrical current from the utility company to backfeed into
the generator. When utility power is restored, the generator may
explode, burn, or cause fires in the building's electrical system.
Ground System
Honda portable generators have a system ground that connects generator
frame components to the ground terminals in the AC output receptacles. The
system ground is not connected to the AC neutral wire. If the generator is
tested by a receptacle tester, it will not show the same ground circuit
condition as for a home receptacle.
Special Requirements
There may be Federal or State Occupational Safety and Health Administration
(OSHA) regulations, local codes, or ordinances that apply to the intended
use of the generator. Please consult a qualifiedlelectrician, electrical inspector,
or the local agency having jurisdiction.
~
l
In some areas, generators are required toi be registered with local utility
companies.
I
l
If the generator is used at a constructionlsite, there may be additional
regulations which must be observed.
,
14