Diagnostic Flowcharts; Flowchart 1: Configuration Test - HP -UX 11i v2 Support Manual

System Library (SysLib)
For more information on ODE, see the Itanium Processor Family (IPF) Offline Diagnostics and Utilities
CD Overview at:

Diagnostic Flowcharts

The diagnostic flowcharts illustrate the following tests:

Flowchart 1: Configuration Test

Flowchart 2: Fibre Channel
Connections Test
Flowchart 3: Boot Test
See the Support Matrix for the Fibre Channel adapter you are troubleshooting for current system
and adapter firmware requirements and other information. Support Matrixes for HP Fibre
Channel adapters are available at:
Figure 3-1 Flowchart 1: Configuration Test
26 Troubleshooting and Maintenance
A set of common routines for use by both the Test Controller
and the Test Modules. These routines perform I/O, string
parsing, and system control.
http://docs.hp.com/en/diag.html#Offline%20Diagnostics
Verifies the configuration of the mass storage interface on
a host using the ioscan (1M) command.
Checks all hardware connections between your system
and Fibre Channel mass storage devices, to confirm that
they are connected and operational.
Verifies that the system boots correctly over Fibre Channel.
http://docs.hp.com/en/netcom.html#Fibre%20Channel
G
Update
System
no
Firmware
1
I
Reinstall
no
Fibre Channel
software
1
1
A
Enter the
ioscan command
B C
HP
yes
Hardware
adapter
state =
displayed?
CLAIMED?
no
D
H
Is
System Firm-
Device
ware version
displayed?
adequate?
yes
E
Enter the
swlist command
F
Is the
FC FILESET
displayed?
yes
2
On Flowchart 2
no
2
Go to Flowchart 2
yes
no
4
Go to Flowchart 2
yes
DONE