Table of Contents
Advertisement
Additional HBAs may be supported; see the HP-UX Fibre Channel (fcd and fclp) Host Bus Adapter
Support Matrix at
information on supported products.
To install the software bundle, follow these steps:
1.
Log in to the system as root.
2.
Insert the CD or DVD into the drive.
3.
Mount the CD using the following command:
mount /dev/dsk/<cd_rom_dev_file> /<tmp_mnt>
4.
Run swinstall to install the software. Enter the following command:
/usr/sbin/swinstall
The Software Selection window and the Specify Source window open.
5.
In the Specify Source window, change the Source Host Name if necessary. Enter the mount
point of the drive in the Source Depot Path field and click OK to return to the Software
Selection window.
Click Help to get more information.
6.
Select the appropriate software bundle for your adapter.
7.
Select Mark for Install from the Actions menu.
8.
Select Install from the Actions menu. Installation begins and the Install Analysis window
opens.
9.
Click OK in the Install Analysis window to confirm that you want to install the software.
The Install window opens.
View the Install window to read processing data while the software installs. When the
Status field indicates Ready, the Confirmation window opens.
10. Click OK. A second Confirmation window opens.
11. Click OK again. The Install window opens.
12. Click Done. The Note window opens.
13. Click OK in the Note window to reboot. The user interface disappears and the system
reboots.
14. Once the system comes back up, log in as root and open the following files to see any error
or warning messages that may have occurred during the installation:
/var/adm/sw/swagent.log
/var/adm/sw/swinstall.log
15. Install OnlineDiag, which is available at http://www.software.hp.com. OnlineDiag is also
available from the HP Support PLUS CD. Installation instructions are available at:
http://docs.hp.com/hpux/onlinedocs/diag/st/st_inst.htm
Installing Adapter Hardware
The Online Addition and Replacement feature, OL* for the HP-UX 11i v3 release, enables PCI
host bus adapters to be added or replaced without shutting down and rebooting the system, and
without adversely affecting other system components. The system hardware uses slot-specific
power control, combined with HP-UX operating system support, to enable these features.
14
Fibre Channel Adapter Installation
http://docs.hp.com/en/netcom.html#Fibre%20Channel
for the most current
Advertisement
Table of Contents
