RX-5502(G) 2007.8.17 4:33 PM 페이지 6
.
4
CONNECTING SPEAKERS
.
5
SWITCHED AC OUTLET
.
6
AC INPUT CORD
• Plug the cord into an wall AC outlet.
• You can connect up to four pairs of
speakers to this receiver and select the
various combinations of speakers according
to your tastes.
• The speakers C and D can be installed in
the main room as the speakers A and B can
or in the another room (ROOM2) for
ROOM2 playback. (For details, refer to
"ROOM2 PLAYBACK" on page 21.)
• Be sure to connect speakers firmly and
correctly according to the channel (left and
right) and the polarity (+ and -).
• If the connections are faulty, no sound will
be heard from the speakers, and if the
polarity of the speaker connection is
incorrect, the sound will be unnatural and
lack bass.
�Notes :
• For safe amplifier operation, use the
speakers with impedance of over 8Ω when
you connect a pair terminals of SPEAKER A
and B terminals or/and a pair terminals of
SPEAKER C and D terminals and use the
speakers with impedance of over 16Ω when
you connect both SPEAKER A and B
terminals or/and both SPEAKER C and D
terminals.
• Do not let the bare speaker wires touch
each other or any metal part of this receiver.
This could damage this receiver and/or the
speakers.
• This outlet is switched on (power-on mode) and off
(standby mode) according to power control as
follows (Maximum total capacity is 100 W (0.43A)).
Standby mode - Switched AC outlet off
Power-on mode - Switched AC outlet on
6