Repair And Maintenance - Razor Espark 13111290 Owner's Manual

REPaIR aND MaINTENaNCE

Turn power switch "OFF" before conducting any maintenance procedures.
q adjusting the Brakes
1
To adjust the brake cable
play, thread the brake lever
adjuster in or out 1/4 to 1/2 turn
until the desired brake adjust-
ment is attained. Most
adjustments are complete at
this step. If brake still needs
further adjustment, proceed to
step 2.
q front Wheel Replacement
1
Using a 10mm open wrench,
loosen the brake cable bolt.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.
2
If brake is too tight or has
too much slack, use a 10mm
open wrench to loosen the
brake cable and adjust accord-
ingly.
2
Using two 17mm open
wrenches, loosen the locknuts
by turning the wrenches counter
clockwise. Remove wheel and
install replacement wheel.
3
Inspect the brake pads (A)
for proper alignment against
the wheel or excess wear. To
realign brake pads, loosen the
fixing nut (B) and adjust the pad
to contact the rim. Retighten
and test. Readjust as needed.
6
Note: Front wheel hardware
sequence
9-1
9-3
9-5
9-4
9-6
9-5
9-3
9-1
9-4
9-2
Right Side (Throttle)
9-5 - (Short) spacer
9-4 - Flat washer
Fork
9-3 - Flat washer
9-2 - Lock washer
9-1 - 17mm locknut
Middle
9-6 - Front axle bolt
Left Side (Brake)
9-5 - (Short) spacer
9-4 - Flat washer
Fork
9-3 - Flat washer
9-2 - Lock washer
9-1 - 17mm locknut
9-2