Seatback Angle Adjustment; Armrest Width Adjustment; Armrest Height Adjustment; Armrest Angle Adjustment - Pride Jazzy 1122 Owner's Manual

V . C O M F O R T

Seatback Angle Adjustment

If your power chair is equipped with an adjustable
seatback, you can adjust it to four (4) different angles:
90°, 102°, 105°, or 107°. See figure 16.
To adjust the seatback angle:
1. Remove the seatback angle adjustment screws from
both seat hinges.
2. Set the seatback at the desired angle.
3. Reinstall the screws to both seat hinges and tighten.

Armrest Width Adjustment

You can change each armrest's width independently of
the other.
NOTE: Changing the armrest width may increase
the overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.

Armrest Height Adjustment

To change the armrest height:
1. Loosen the two setscrews located on the armrest re-
ceiver.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.

Armrest Angle Adjustment

To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular
to the floor.
2. Loosen the jam nut. See figure 16.
3. Loosen the armrest angle adjustment screw. See fig-
ure 16.
4. Turn the adjustment screw clockwise to raise the front
of the armrest, or turn the adjustment screw counter-
clockwise to lower the front of the armrest.
5. Tighten the jam nut to lock the adjustment screw into
place.
Jazzy 1122
A D J U S T M E N T S
ARMREST
ANGLE
ADJUSTMENT
SCREW
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
SEATBACK
ANGLE
ADJUSTMENT
SCREW
ARMREST KNOB
Figure 16. Seatback and Armrest Adjustments
www.pridemobility.com
JAM NUT
23