Seat Position; To Change The Seat Position; Manual Recline Seatback Adjustment; Headrest Height Adjustment - Pride Jazzy 1122 Owner's Manual

V . C O M F O R T A D J U S T M E N T S
NOTE: Make sure the seat latch safety is flipped down before
using the power chair seat.
15. Plug the controller connector(s) into the electronics tray.

Seat Position

You can move the seat forward or rearward by changing the extru-
sion mounting position.

To change the seat position:

1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the electronics tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
SEAT MOUNTING HOLES
5. Reposition the extrusions on a different set of mounting holes.
You must move both extrusions the same number of holes either
forward or backwards. See figure 15.
Figure 15. Seat Position Adjustment
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller connector(s) into the electronics tray.

Manual Recline Seatback Adjustment

If your power chair is equipped with a reclining seat, you can adjust
the seatback angle with the seatback release lever. The lever is lo-
cated on the right side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.

Headrest Height Adjustment

If your power chair is equipped with an optional deluxe high-back
seat, you can adjust the headrest height.
To adjust the headrest height:
1. Push in the headrest release button.
2. Move the headrest up or down to the desired position.
22 www.pridemobility.com Jazzy 1122