Extron electronics VSW 2VGA A User Manual page 17

2-input, 1-output vga and audio switcher

Hide thumbs Also See for VSW 2VGA A:

Table of Contents

Attach the through-desk mounting brackets

(MBD 129, part #70-077-02) to the VSW 2VGA A with the

four provided machine screws, as shown in the through-

desk mounting diagram on the next page.

Hold the switcher with attached brackets up against the

underside of the desk or table. Use a soft pencil to mark

the locations of the holes for the screws that will attach the

brackets to the desk.

Drill 1/4 inch (6 mm) deep, 3/32 inch (2 mm) diameter

pilot holes in the desk or table at the marked screw

locations. The holes should be drilled from the underside

or inside (concealed side) of the furniture, where the

switcher will be located.

Attach the switcher to the desk or table with the provided

wood screws, as shown in figure 2-4.

Figure 2-4 — Through-desk mounting

To adjust the height of the switcher within the desk,

slightly loosen the screws that attach the brackets to the

switcher, adjust the height by sliding the switcher up or

down, and retighten the screws.

VSW 2VGA A • Installation and Operation

2-7

Table of Contents