Table of Contents
Advertisement
IP Address - The IP Address of the PC running the service application
Protocol - The protocol used for this application, either TCP or UDP, or All (include
all protocol that can be accessed by the Router).
Enable - The Enable checkbox to enable the virtual server entry.
Common Service Port – Some common services already exist in the pull-down
list.
To setup a virtual server entry:
1. Select the service you want to use from the Common Service Port list, and
select the ID you want to use, and click Copy to button. If the Common
Service Port list does not have the service that you want to use, type the
number of the service port or service port range in the Service Port box.
2. Type the IP Address of the computer in the Server IP Address box.
3. Select the protocol used for this application, either TCP or UDP, or All.
4. Select the Enable checkbox to enable the virtual server.
5. Click the Save button.
Note: It is possible that you have a computer or server that has more than one type of
available service. If so, select another service, and enter the same IP Address for that
computer or server.
To modify a virtual server entry:
1. Select the entry you want to modify.
2. Modify the information from the Service Port, the IP Address boxes, and the
Protocol pull-down list.
3. Click the Save button.
To delete a service entry:
1. Clear the entry's all information except the Protocol pull-down list.
2. Click the Save button.
To delete all service entries:
3.
Click the Clear All button.
4.
Click the Save button
Click the Next button to go to the next page and Click the Previous button to return the
previous page.
Note: If you set the virtual server of service port as 80, you must set the web
management port on Security –> Remote Management page to be any value except
80 such as 8080. Or else there will be a conflict to disable the virtual server.
TL-WR542G
- 35 -
54M Wireless Router User Guide
Advertisement
Table of Contents
