HP OmniBook 800CS/CT Service Manual page 61

Hp omnibook service manual
Table of Contents

Advertisement

Symptom
fault – insert valid boot disk
and press any key"
Error message: "Auto IDE
error" or "HDD not ready"
Lockup/computer freezes
After warm docking
After hot docking
After undocking
While booting
After turning on
When shutting down, during
"Windows 95 Shutting Down"
screen
Keyboard
Keys stiff
42
Call Center
Verify latest BIOS (v1.02.00).
Send in for repair.
Verify latest BIOS (v1.02.00).
Does the user have an external
monitor? If so, BIOS versions
after 1.00.00 may exhibit this
problem about 5% of the time. A
future revision of the BIOS will
address this issue.
Is there a card in dock? Remove
card from undocked
configuration.
Is the user an HP COE user? If
so, does the user use COE
Connect and COE Disconnect?
If not, refer them to their IT dept.
for instructions.
Press reset button.
If ineffective, can user boot from
floppy? If no, send in for repair.
If yes, run CHKDSK /f on hard
drive, then attempt to boot from
HD again.
New BIOS v 1.02.00
Microsoft has a web page to help
with these problems, which are
usually the result of driver
conflicts.
(www.microsoft.com/kb/articles/q
145/9/26.htm)
If HP COE user, make certain
they are using COE Disconnect.
Refer them to their IT
department.
Is customer comparing OB800
keyboard to other notebook or
desktop keyboards? Is customer
Repair Center
and not trapped under them
(where they can short hard
drive PCA). Then try another
hard drive. If problem is
solved,
original HD may be corrupted,
have a virus or be defective. If
problem persists, reinstall old
HD and try replacing the CPU
board and if that doesn't work,
then replace the logic board.
New BIOS v 1.02.00
Can you boot from floppy? If
no, replace CPU first, then
logic board. If yes, run
CHKDSK /f on hard drive, then
attempt to boot from HD again.
Run Scandisk to check for HD
platter defects. Verify
keyboard support plate is of
later design or has I/O insulator
(Service Note 800-09).
New BIOS v 1.02.00. Try
replacing HD, then CPU, and
then logic board.
If the keyboard is stiff, replace
with a new keyboard of
datecode Aug 1 or later.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omnibook 800csOmnibook 800ct

Table of Contents