HP OmniBook 800CS/CT Service Manual page 110

Comparison
Trigonometry
Memory test responses
Suspend RAM test
Extended Pattern And
Address Test
Base/UMB Pattern And
Address Test
Base/UMB Bus Throughput
Test
EMS Bus Throughput Test
EMS Pattern And Address
Test
Code Test
Cache test responses
Cache Test
VGA test responses
Video Pages
Video Memory
Color Registers
VGA Controller Registers
"FBLD/FBSTP", "FILD/FIST","FLD/FST","FXCH" -- "FAILED"
"FCOM","FICOM","FTST","FXAM" -- "FAILED"
"FUCOM" -- "FAILED"
"F2XM1","FPATAN","FPTAN","FYL2X","FYL2XP1" -- "FAILED"
"FCOS","FSIN","FSINCOS" -- "FAILED"
"Failed: memory manager loaded"
"Could not allocate buffer"
"BIOS reports no extended memory available"
"Error at address XXXXXXXXH"
"Parity Error at blocks XXXXXXXH-YYYYYYYYH"
"Parity Error at blocks XXXXXXXH-YYYYYYYYH"
"Test aborted at block XXXXXXXH"
"Error at memory paragraph XXXXH"
"Parity Error at paragraphs XXXXH-YYYYH"
"Test aborted at paragraph XXXXH"
"Error at segment XXXXH"
"Bus Throughput Test aborted at segment XXXXH"
"Not Enough EMS Memory Available!"
"Could Not Allocate EMS Memory!"
"Error at segment XXXXH"
"Could Not Establish EMS Page Frame Location!"
"Error on page XXXXX"
"Parity Error on page XXXXX"
"Test aborted at EMS page XXXXX"
"BIOS reports no extended memory available"
"PC-DOCTOR encountered an unexpected exception while code-
testing memory in protected mode. System halted (this error is
unrecoverable).'"
"Error at memory block XXXXXXXH"
"Parity Error at blocks XXXXXXH-YYYYYYYH"
"Test aborted at block XXXXXXXXH"
"Aborted at mode XXXH (III)"
"Mode XXXH (III) page Y failed"
"Pattern Error in mode XXXH (III) plane Y, bits XXXXH Failed"
"Pattern Error in mode XXXH (III) bits XXXXH Failed"
"Could not initialize mode 13H"
"DAC-register N " -- "Red ", "Green ", "Blue " -- "FAILED"
"Video RAM Enable" -- "FAILED"
"Video IRQ" -- "FAILED"
"Map Mask Register" -- "FAILED"
"Set/Reset Register" -- "FAILED"
"Enable Set/Reset Register" -- "FAILED"
"Color Compare Register" -- "FAILED"
"Data Rotate Register" -- "FAILED"
"Read Map Select Register" -- "FAILED"
91