HP OmniBook 600CT Familiarization Manual page 40

Hewlett-packard notebook pc familiarization guide
Hide thumbs Also See for OmniBook 600CT:
Table of Contents

Advertisement

PhoenixBIOS
POST Messages
(Power On Self
Test
Message
Diskette drive failure
Diskette drive x failure where x=O or x=1
Diskette read failure - press Fl to retry boot (or may
also say, press Fl to retry boot, F2 for SETUP utility)
Display adapter failed; using alternate
Gate A20 failure
Fixed disk configuration error
Fixed disk controller failure
Fixed disk failure
Fixed disk read failure -press Fl to retry boot (or may
also say press Fl to retry boot, F2 for SETUP utility)
Internal cache test failed -cache is disabled
Pointer device failure
No boot device available -Press Fl to retry boot (or
may also say, press Fl to retry boot, F2 for SETUP
utility)
Message
Within POST, there are three kinds of messages:
Error messages: These messages appear when there is a failure in hardware,
software, or firmware.
Informational messages: These messages provide information to the user but require
no action.
Beep codes: This kind of warning sounds when POST errors occur and the screen is
not available.
Because the OmniBook cannot be repaired by a service center below the FRU level,
these messages will provide limited troubleshooting or repair information. However,
the support specialist and service technician will be able to identify trends in repairs
from these codes.
Possible Cause
The 0 or 1 drive failed or is missing.
The designated drive has either failed or is missing.
The diskette is either not formatted or is defective.
The color/monochrome switch is set incorrectly. The
primary video adapter failed.
The keyboard controller is not accepting commands,
specifically, the enable and disableA20 commands.
The specified configuration is not supported or doesn't
match the actual hardware
The controller card has failed.
The fixed disk may be defective.
The fixed disk may be configured incorrectly or is
defective.
Faulty cache memory in the 80486 processor chip.
The mouse failed.
Either diskette drive A:, the fixed disk, or both the
diskette and disk are defective.
Possible Cause
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omnibook 600c

Table of Contents