To Remove A Pc Card; To Insert And Remove A Cd - HP OMNIBOOK 3000 User Handbook Manual

To remove a PC Card

Caution
Never remove an I/O card while an application is open that's set up to use that
card. Exit the application first. If you remove the card, the application (or the
OmniBook) might behave unpredictably or stop responding until you reset the
OmniBook.
Never insert or remove a plug-in card while the PC Card drive is actively
reading or writing data. Check the PC Card indicator in the status panel and
wait until the PC Card drive is done. Otherwise, you could lose data or the
OmniBook could stop responding.
1. Stop the PC Card by clicking the PC Card indicator in the taskbar, then clicking
Stop.
This protects your data and avoids unexpected problems. You can restart the
card by removing it, then inserting again.
2. Press the ejector button once to pop it out, then press it again to pop the card
out.

To insert and remove a CD

When the OmniBook is reading data from the CD-ROM drive, the
CD-ROM/hard disk drives indicator appears on the status panel.
Caution
Do not insert or remove a CD while the OmniBook is actively reading data.
Wait until the CD-ROM drive is done. Otherwise, the OmniBook could stop
responding.
1. Press the button on the face of the CD-ROM drive (on the right side of the
OmniBook).
23