To Insert A Pc Card - HP OMNIBOOK 3000 User Handbook Manual

To remove the floppy disk, press the eject button next to the slot.

To insert a PC Card

The OmniBook PC card slots are available for storing data and expanding the
communication capabilities of the OmniBook. The OmniBook supports standard
Type I, II, and III PC Cards (PCMCIA and CardBus). You can use two type I or II
cards or one type III card. The lower card slot (slot zero) supports Zoomed Video,
which allows a zoomed video card to show high-quality multimedia presentations.
For information about compatible cards, visit our website at
http://www.hp.com/go/omnibook. Or contact Hewlett-Packard as described in the
Support and Service booklet.
Caution
Do not install Card Services or Socket Services software if it comes with your
PC Card. The OmniBook already includes Card Services and Socket Services,
which automatically detect and set up PC Cards you install in the upper and
lower card slots. Different versions of this software will disrupt this support.
Never insert or remove a plug-in card while an OmniBook PC Card drive is
actively reading or writing data. Wait until the PC Card drive is done.
Otherwise, you could lose data or the OmniBook could stop responding.
The OmniBook automatically detects and sets up a card when you insert it in a card
slot. See the card's instructions for additional information.
Hold the card with its face up and its connector holes toward the card slot, then
slide it into a PC Card slot until it won't go any further. A double beep signals
that the card has been recognized and is successfully configured by your
computer.
When the card is active (the computer is accessing it), the PC
Card indicator appears on the status panel.
22