Table of Contents
Advertisement
Connecting your system
TELUS TV digital box, TV and audio/video receiver
TV
THE BACK OF YOUR
TV MAY NOT LOOK
EXACTLY LIKE THE
DIAGRAM SHOWN
HERE
A/V RECEIVER
THE BACK OF YOUR
RECEIVER MAY NOT
LOOK EXACTLY
LIKE THE DIAGRAM
SHOWN HERE
2B
ETHERNET
WALL
OUTLET
TELUS TV
DIGITAL BOX
5
1. Connect the TELUS TV digital box to the TV directly (A)
or through a modulator (B):
A. Connect the video cable to the VIDEO OUT jack
(yellow) on the back of the TELUS TV digital box
and the other end of the cable to the corresponding
input jack on the TV (sometimes labelled VIDEO).
NOTE: If your TV has an S-Video input, we recommend you make the
video connection by using this jack instead of using the VIDEO jack.
Remember to connect the audio cables for this connection as S-Video
only carries the picture signal, not the sound.
– OR –
B. If your TV doesn't have audio/video input jacks,
your TELUS installer will provide you with an RF
modulator. Connect the audio/video cables to the
RF modulator and to the TELUS TV digital box.
Be sure to plug the white connector cable into
the white jack on your TELUS TV digital box and
likewise for the red and yellow connectors.
12
AUDIO
VIDEO
R
L/MONO
IN
CABLE/
ANTENNA
OUT
S-VIDEO
1A
CD
TAPE
TV
VCR
IN
IN
OUT
IN
IN
OUT
L
2A
ETHERNET
VIDEO
POWER
AUDIO RIGHT
3
AUDIO LEFT
2. Connect the A/V receiver to your TELUS TV digital box
(2 methods):
A. Connect the audio cables to the AUDIO OUT R
and L jacks on the back of the TELUS TV digital
box (colour coded, red and white). Connect the
other ends of the cables to the corresponding
input jacks on the A/V receiver (sometimes labelled
AUDIO L/MONO and AUDIO R). You may also want
to connect VIDEO to your receiver (or TV, using
instructions on the previous pages).
– OR –
B. If you have an A/V receiver with a digital optical
jack, remove the protective cap from your digital
optical cable.
Connect one end of the digital optical cable to
the OPTICAL AUDIO OUT jack on the back of the
TELUS TV digital box and the other end to the
corresponding input jack on your A/V receiver
(sometimes labelled OPTICAL IN). You may also
want to connect Video to your receiver (or TV using
instructions on the previous pages).
NOTE: If you are using your A/V receiver as a video switch for your TV
set, connect the Video or S-Video output on your TELUS TV digital
box to the corresponding jacks on your A/V receiver. Then connect the
Video output on your A/V receiver to the Video input on your TV set.
3. Connect the Ethernet cable (yellow). Connect one end
of the Ethernet cable to the ETHERNET WALL OUTLET
(a TELUS TV technician will have installed this) and the
other end to the ETHERNET jack located at the back of
the TELUS TV digital box.
4. Ensure that your High Speed Internet (ADSL) modem
is on and connected. This connection will likely be
found in the same room as your computer.
5. Plug the power supply into the TELUS TV digital box
power jack and find a suitable AC power outlet for your
box. However, DO NOT plug the digital box into the
power outlet at this time.
6. Go to Initializing your TELUS TV digital box on page 13.
Advertisement
Table of Contents
