Bushnell ImageView 11-8200 Instruction Manual page 8

TAKING A PICTURE
With the camera turned on, press the SNAP button to take a new photo. For best results, hold
the ImageView steady using both hands, and lightly press down the SNAP button using the
flat end of your finger rather than "punching" it with a fingertip. Be sure you are at least 30
feet away from your subject as the camera focus is preset for optimum results with distant
objects (ie: sports, wildlife, etc.).
CHANGING OPERATIONAL MODES
Pressing the MODE button briefly will cycle through several special camera modes and settings.
A corresponding icon or symbol (indicated in parentheses below) will be displayed on the LCD
for each mode as you cycle through them by tapping the MODE button, and blink unless you
select or confirm it with the SNAP button (icon will stop blinking). If no button is pressed for
more than 5 seconds, the camera will return to normal operation. The modes/settings are
shown as you cycle through them in the following order:
) : selects the self-timer, which will take a photo after a 10 second delay when you
• Timer (
press the SNAP button. This is useful for avoiding blurry photos from bumping the camera
when it is mounted on a tripod (optional), especially in low light conditions. Once set, the
camera will remain in self timer mode until you return to the timer mode setting and turn
it off.
Full
Low
Dead
022
3M
• Repeat Shot (
H
M
L
when you press and hold the SNAP button. As with the timer, the camera will remain in
*
**
***
2
022
ON
3M
Full
H
) : Takes rapid series of 3 consecutive photos, approx. 1 second apart, * M Low
**
*** L Dead