Windows Clients Using Lantastic - Axis PrintPoint 140 BJC User Manual

Section 4: Setting Up - Windows
Client-Server Printing:
Client Setup

Windows Clients using LANtastic

Note:
50
Follow these steps to use your AXIS PrintPoint 140 BJC for
client-server printing at a Windows for Workgroups client:
1. In the Control Panel, select Printers.
2. Select a printer driver from the list of Installed Printers, or click
Add>> to install a new driver. Click Connect...
3. Select Network... in the Device Name list, select a local port
(LPT1- LPT3) to redirect to your network printer.
4. In the Show Shared Printers on list, select the server from Server
Setup above.
5. In the Shared Printers list, select the printer you want to use.
6. Click OK, OK and Close.
7. Exit the Control Panel.
The client setup is completed and you can now print through your
AXIS PrintPoint 140 BJC.
From any Windows client, the AXIS PrintPoint 140 BJC may also be
used for networks printing within LANtastic environments.
LANtastic users may use the AXIS Print Utilities in exactly the same
manner as described in the proceeding Windows sections, using a
choice of Axis utility software that is guided by the type of Windows
client employed:
• Refer to Using the AXIS Print Utility for Windows if you are using
a Windows for Workgroup client.
• Refer to Using the AXIS Print Monitor for Windows 95 and NT if
you are using either a Windows 95 or Windows NT client.
AXIS Print Monitor and AXIS Print Utility for Windows uses
NetBIOS/NetBEUI for printing, so make sure that your
LANtastic client is running this protocol.
AXIS PrintPoint 140 BJC User's Manual