Host Set-Up - Ibm As/400, 3270 Cu Mode - Axis 570 User Manual

SNA
Section 3: Setting Up - SNA

Host Set-up - IBM AS/400, 3270 CU mode

Before you begin
Set-up
Notes:
54
You have decided that the AXIS 570/670 MIO is going to run in
3270 CU mode. This does not provide optimum AS/400
performance; the 5250 CU mode is recommended.
Have the serial number, found on the back of the AXIS 570/670
MIO, available.
The set-up consists of four steps:
1. Creating a controller description.
2. Creating a printer device description.
3. Initializing communication.
4. Verifying the communication.
On the following pages you will find sample controller and printer
descriptions.
You will only be able to print plain text. Native AS/400 printout
is limited to 10 CPI and 132 columns per line. The full
functionality of OfficeVision (justification, etc.) cannot be
utilized, as only 3270-type printers can be emulated by the AXIS
570/670 MIO in 3270 CU mode. The font to be used can,
however, be selected. See Extended IBM Printer Emulation on page
149.
If you have TCP/IP installed on the AS/400, you may wish to use
it to print. See Section 8 Setting Up - UNIX.
The sample below assumes that local station address etc. has not
been changed in the AXIS 570/670 MIO. The values that should
be entered are in bold. The underlined values must be entered
exactly as shown.
AXIS 570/670 MIO User's Manual