Connecting The Axis 670 Mio To The Token Ring Network - Axis 570 User Manual

Connecting the AXIS 670 MIO to the Token Ring Network

Caution
AXIS
670 MIO
Notes:
AXIS 570/670 MIO User's Manual
DO NOT connect or disconnect the network cabling while the AXIS
670 MIO is powered on, otherwise the equipment maybe damaged.
1. Switch off the printer.
2. Connect an STP (Media Type 1) or UTP (Media Type 3) cable to
the AXIS 670 MIO.
3. Switch on the printer.
4. Successful connection of the AXIS 670 MIO to you network will
be confirmed by the intermittent flashing of the Network
Indicator.
5. You are now ready to install your server onto your network using
one of the methods detailed in the Installation Guide, on page 20.
By commencing with your preferred installation method, you can
further very that your AXIS 670 MIO is properly connected to
your network.
To minimise signal noise it is recommended that you use screened
or foiled Media Type 3 cabling for 16 Mbit networks and not
standard UTP cabling.
Each AXIS 670 MIO Print Server is pre-configured with a unique
Node Address that is identical to the serial number. This can be
changed using the AXIS NetPilot™, the Front Panel of the
printer or any standard Web browser using HTTP, if required.
Section 2: Basic Installation
19