Frost-Free Storage - Philips HD7854 User Manual

Note:
D
Always put a used coffee pod in the pod
holder when you descale the machine. This
pod serves as a 'filter' to prevent the sieve
in the pod holder from getting clogged with
scale residues.
Mix 50 grams of citric acid with 1 litre of
3
water in a measuring jug. Stir until the powder
has completely dissolved (Fig. 48).
Remove the water reservoir and fill it
4
with the descaling mixture. Then put the
water reservoir back onto the coffee
machine (Fig. 49).
Put a bowl with a capacity of at least 1.5
5
litres under the spout to collect the descaling
mixture. (Fig. 3)
Press the on/off button 3 to switch on the
6
machine. (Fig. 7)
• The machine is ready for descaling when
the light ring around the on/off button lights
up continuously.
Press the CLEAN/CALC CLEAN button to
7
start the descaling cycle. (Fig. 50)
Warning:
B
Never interrupt the descaling cycle. If you
interrupt the descaling cycle, see chapter
Troubleshooting for further instructions.
• The CALC light and the light ring around
the on/off button start to flash slowly
to indicate that the descaling cycle has
started.
•
The descaling cycle takes approx. 35 min.
During this cycle, hot water comes out of
the coffee spout at intervals because the
machine pauses several times to let the
descaler mixture act (Fig. 51).
•
When all the water in the water reservoir
has been used up, the descaling cycle is
finished. The light ring around the on/off
button starts to flash rapidly to indicate
that the water reservoir is empty.
14
8.1.2 Rinsing cycle
Empty the bowl and place it back under the
1
spout (Fig. 52).
Rinse the water reservoir (Fig. 53).
2
Fill the water reservoir with fresh tap
3
water and place it back onto the coffee
machine (Fig. 54).
Note:
D
Do not refill the water reservoir with used
hot water or the used descaling mixture.
• The machine is ready for the rinsing cycle
when the on/off light lights up continuously.
Press the CLEAN/CALC CLEAN button to
4
rinse the machine. (Fig. 50)
• During the rinsing cycle, the indicators
on the control panel on the lid light up
anticlockwise sequentially to indicate that
the machine is rinsing.
Note:
D
The rinsing cycle takes a few minutes.
Repeat steps 1 to 4 one more time.
5
Note:
D
When all the water in the water reservoir has
been used up, the rinsing cycle is finished and
the appliance switches off automatically.
Remove the Calc-Clean tool from the coffee
6
spout.
Remove the used pod and clean the pod
7
holder to prevent the sieve in the centre from
getting clogged.

9 Frost-free storage

If the coffee machine has already been used and
therefore has been flushed with water, it may
only be used and stored in a frost-free place to
prevent it from becoming damaged.