Cleaning The Machine; Flushing The Coffee Machine - Philips HD7854 User Manual

7 Cleaning the
machine
Danger:
A
Never immerse the machine in water or any
other liquid.
7.1 Cleaning the coffee
machine
Always unplug the machine before you clean it.
1
Clean the outside of the machine with a damp
2
cloth.
Remove the coffee collector (Fig. 36).
3
Remove the coffee spout cover and take the
4
coffee spout out of the machine (Fig. 37).
Clean the coffee spout cover, the coffee
5
spout, the coffee collector and the drip tray in
hot water, if necessary with some washing-up
liquid, or in the dishwasher (Fig. 38).
Hold the cup tray in your hand while you
6
clean it with hot water. If necessary, use some
washing-up liquid (Fig. 39).
The cup tray can also be cleaned in the
dishwasher.
Warning:
B
To clean the cup tray, always remove it
from the machine. It may prove sharp when
handled incorrectly. Always handle it carefully.
Clean the pod holders in hot water, if
7
necessary with some washing-up liquid, or in
the dishwasher. (Fig. 40)
If the sieve in the centre of the pod holder is
clogged, rinse the pod holder under a running
tap. If necessary, use a washing-up brush.
Clean the water reservoir in hot water,
8
if necessary with some washing-up
liquid. (Fig. 41)
Note:
D
If you use a washing-up brush, be careful not
to damage the valve and float in the bottom
of the water reservoir.
12
Note:
D
The water reservoir can also be cleaned in
the dishwasher.
Clean the water inlet on the machine with a
9
moist cloth (Fig. 42).
Warning:
B
Do not use an object with sharp edges to
clean the water inlet.
Rinse the parts with fresh water after cleaning
10
and put them back into the machine.
Clean the water distribution disc with a moist
11
cloth (Fig. 43).
Be careful when you do this. Make sure that
the rubber sealing ring does not get stuck
under the edge of the water distribution disc.
If it does, the coffee machine starts leaking.
Note:
D
Be careful not to damage the metal tab on
the water distribution disc.

7.2 Flushing the coffee machine

If you have not used the coffee machine for three
days, you have to flush it with fresh water to refresh
the water in the boiler before you use it again.
Flush the machine in the following way:
Fill the water reservoir with cold water up to
1
the MAX indication and put it back onto the
machine. (Fig. 4)
Put the 1-cup pod holder q or the 2-cup pod
2
holder qq in the machine without pod or
pods. (Fig. 44)
Close the lid and lock the lid lever (Fig. 18).
3
Put a bowl (with a capacity of 1.5 litres) under
4
the coffee spout to collect the water (Fig. 3).
Press the on/off button 3. (Fig. 7)
5
• The light rings around the 1-cup button q and
the 2-cup button qq light up continuously.
To start flushing, press the 1-cup button q
6
and the 2-cup button qq briefly at the same
time. (Fig. 8)
During the flushing cycle, the water in
•
the water reservoir is flushed through
the machine and the boiler is filled with
fresh water. The flushing cycle takes some
time (approx. 90 to 150 seconds).