Factory Settings - NETGEAR WNDR4300-TN User Manual

N750 Wireless Dual Band Gigabit Access Point WNDR4300-TN

Factory Settings

You can return the access point to its factory settings. Use the end of a paper clip or a similar
object to press and hold the Restore Factory Settings button on the back of the access
point for at least five seconds. The access point resets and returns to the factory
configuration settings shown in the following table.
Feature
Access point User name (case-sensitive)
login
Login password (case-sensitive)
Local network LAN IP address
(LAN)
Subnet mask
Time zone
Time zone adjusted for daylight
saving time
Allow a registrar to configure this
router
Wireless Wireless communication
SSID name
Network key
Channel width - 2.4 GHz
Channel width - 5 GHz
Security
Broadcast SSID
Transmission speed
Country/region
RF channel
WiFi standard
* Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput can vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data
throughput rate.
Default behavior
admin
password
192.168.0.51
255.255.255.0
GMT +01:00
Disabled
Enabled
Enabled
See access point label
See access point label
20 Mhz
Auto
WPA-PSK(TKIP) + WPA2-PSK(AES)
Enabled
*
Auto
Europe
Auto
2.4 GHz: b/g/n
5 GHz: a/n
Supplemental Information
43