Installing Usb Drivers - THOMSON SPEED TOUCH 580 Installation And Setup Manual

Chapter 3
Internet Access in No Time

3.1.2 Installing USB drivers

USB connection
Supported operating
Installing Windows USB
18
You may want to connect your computer to the SpeedTouch™ using the USB port.
To be able to do so, you must install the corresponding USB driver.
USB connection on the SpeedTouch™ is supported for following
systems
Microsoft Operating Systems:
MS Windows 98SE
MS Windows Millennium
MS Windows 2000
MS Windows XP
You may need the Windows installation CD during installation.
The installation procedure might be slightly different depending on the
MS Windows OS you are using.
Mac Operating Systems:
Mac OS X 10.2 (Jaguar)
Mac OS X 10.3 (Panther)
The first time you connect the SpeedTouch™ to your computer through a USB
drivers interface, as soon as you plug the USB cable into the computer, you will be prompted
for a USB driver.
You will find the required USB driver software on the Setup CD, you just entered in
your computer's CD-ROM or DVD-ROM drive. The installation is plug and play,
meaning that installation will require almost no effort.
Proceed as follows:
Insert the blue USB cable provided into the SpeedTouch™ USB port marked with
1
the USB logo.
An USB logo looks like this:
The other end of the USB cable fits in (one of) the USB port(s) of your
2
computer. In most cases your computer's USB port is marked with the same
USB symbol.
You can also connect your computer to the SpeedTouch™ via a USB
hub, provided that the hub is autonomously powered.
Windows will automatically recognise the Thomson USB Remote NDIS device:
3
E-DOC-CTC-20050429-0061 v1.0