Table of Contents
Advertisement
Switching off the appliance
If the appliance is not going to be used for an extended period:
1.
Remove all deep-frozen packages as well as ice trays.
2.
Switch off the appliance by holding down the ON/OFF button.
3.
Remove the mains plug or switch off or turn out the circuit breaker or fuse.
4.
Clean thoroughly (see section: "Cleaning and Care").
5.
Leave the door open to avoid the build up of odours.
Energy Saving Tips
• Do not install the appliance near cookers, radiators or other sources of
warmth. High ambient temperatures cause longer, more frequent
operation of the compressor.
• Ensure sufficient air circulation and exhaust at the appliance base and at
the back wall of the appliance. Never cover air vent openings.
• Do not place warm foods into the appliance. Allow warm foods to cool first.
• Only leave door open as long as necessary.
• Do not set temperature any colder than necessary.
• Put frozen food in the fridge to defrost. The cold in the frozen food will
then be used to cool the fridge.
• Keep the heat emitting condenser, the metall grille on the rear wall of
your appliance, always clean.
40
Your appliance needs air
For
safety
reasons,
minimum
ventilationmust be as shown Fig.
Attention:
keep
ventilation
openings clear of obstruction;
Rear spacers
In the bag with the documentation,
there are two spacers which must be
fitted.
Slacken the screws and insert the
spacer under the screw head, then
re-tighten the screws.
Fitting the Door Handles
1.
Screw the top handle
bracket to the handle rod
(1). Fit the bottom handle
bracket on the lower left-
hand side of the door (2).
2.
Fit the top handle bracket
on the top left-hand side
of the door (3) and screw
the handle rod to the
bottom handle bracket (4).
Attention!
Do not overtighten the
screws (max. 2 Nm) as you
may damage the door
handles.
A
B
NP007
PR153
29
Advertisement
Table of Contents
