Table of Contents
Advertisement
Remove transport safeguard
The appliance and the interior fittings are protected for transport.
• Pull off the adhesive tape on the left and right side of the door.
• Remove all adhesive tape and packing pieces from the interior of the
appliance.
Installation
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance should
therefore
– not be exposed to direct sunlight;
– not be installed next to radiators, cookers or other sources of heat;
– only be installed at a location whose ambient temperature corresponds to
the climate classification, for which the appliance is designed.
The climate classification can be found on the serial plate, which is located
at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each
climate classification: each climate classification:
Climate classification
SN
N
ST
T
If installation next to a source of heat is unavoidable, the following
minimum clearances must be maintained at the sides of the appliance:
– for electric cookers 3 cm;
– for oil and coal fired ranges 30 cm.
If these clearances cannot be maintained a heat insulating pad is required
between the cooker and the refrigeration appliance.
If the refrigeration appliance is installed next to another refrigerator or
freezer a clearance of 5 cm at the sides is required, in order to prevent the
formation of condensation on the outside of the appliance.
28
for an ambient temperature of
+10 bis +32 °C
+16 bis +32 °C
+18 bis +38 °C
+18 bis +43 °C
What to do if ...
Correcting Malfunctions
A malfunction may be caused by only a minor fault that you can rectify
yourself using the following instructions. Do not perform any other work on
the appliance if the following information does not provide assistance in
your specific case.
Warning! Repairs to refrigerators/freezers may only be performed by
qualified service engineers. Improper repairs can give rise to significant
hazards for the user. If your appliance needs repairing, please contact your
specialist dealer or our Customer Service.
Malfunction
Appliance is not switched on Switch on the appliance.
Mains plug is not plugged in
or is loose.
Appliance does not work, no
pilot light is illuminated.
Fuse has blown or is defective.
Socket is defective.
Green light does not light up,
yellow light lights up when
Green light faulty.
fast freeze fuction is
activated, appliance is on.
Yellow light does not light up,
when fast freeze fuction is
Yellow light faulty.
activated, appliance is on.
Appliance cools too much.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
The freezer temperature is not
was placed in the appliance
sufficient, red light lights up,
within the last 24 hours.
temperature signal sounds
The appliance is near a heat
source.
Disturbance on the appliance
Possible Cause
Remedy
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
Please inform your customer
service
Please inform your customer
service
Turn the temperature
regulator to a warmer setting
temporarily.
Please look in the "Initial Start
Up" section.
Open the door only as long as
necessary. Press the
FROSTMATIC button
Press the FROSTMATICbutton
Please look in the "Installation
location" section.
Switch on the FROSTMATIC
button, keep the freezer
closed, inform your customer
service
41
Advertisement
Table of Contents
