Electrolux ARCTIS 75278 GA User Manual page 10

begin to defrost.
2. Press the fast freeze button 24 hours before introducing fresh food for
freezing of fresh food. The yellow light comes on.
3. Place frozen foods in the drawers sorted by type, as far as possible.
Preparation of Ice Cubes
1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer
compartment and leave to freeze.
2. To loosen the frozen cubes, either bend the ice cube tray or hold it under
running water for a few seconds.
Important! Never try to free an ice tray that is frozen to the freezer
compartment using pointed or sharp edged objects. Use the ice scraper
supplied.
Ice pack
There are two ice packs in one drawer of the freezer.
In the event of a power failure or malfunction, the ice packs will lengthen
the amount of time it takes for the frozen food to become too warm by
several hours. The ice packs can only fulfil this task optimally if it is placed
in the uppermost drawer, at the front, above the frozen food. You can use
the ice packs for cooling cold bags.
Defrosting
Freezer
The inner walls of the freezer are automatically defrosted.
38
8) Remove from the ventilation
grille the cover (e) and refit it on
the opposite side.
9) Refit ventilation grille.
10) Unscrew the top handle
bracket from the handle rod (1).
Unscrew the bottom handle
bracket from the door (2).
Unscrew the top handle
bracket from the door (3) and
screw onto the bottom right-
hand side of the door (4).
Turn the handle bracket with
the handle rod 180° and screw
them to the door (5) and the
fitted handle bracket (6).
Move the small plug from right
to left.
Reposition, level the
appliance, wait for at least
one hour and then connect it
to the mains socket.
In any case you do not want to
carry out the above mentioned
operations, contact the nearest
After Sales Service Force. The
After Sales Service specialist
will carry out the reversibility
of the doors at your cost.
Attention:
After having reversed the opening direction of the doors check that all the
screws are properly tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. in that case, wait for the natural fitting of
the gasket or accelerate this process by heating up the part involved with a
normal hairdrier.
31