Figure 3.7: Oscar Interface Scan Dialog Box - Avocent AutoView 3200 Installer/User Manual

NOTE: Scanning is available only to local users.
To add target devices to the Scan list:
1. If the OSCAR interface is not open, press
2. Click Setup - Scan to open the Scan dialog box shown in Figure 3.7.

Figure 3.7: OSCAR Interface Scan Dialog Box

3. Determine the order within the list to add the target device. If there are no target devices in the
Scan list, your cursor will appear in a blank line at the top of the list.
-or-
To add a target device to the end of the list, place your cursor in the last target device entry and
press the
Down Arrow
-or-
To add a target device within an existing list, place your cursor in the line below where you
want to insert a new target device and press
4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
a. Press
Alt+Down Arrow
b. Press
Alt+Up Arrow
c. Press
Alt+Home
d. Press
Alt+End
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
key.
to move the cursor down through the list of target devices.
to move the cursor up through the list of target devices.
to move the cursor to the first target device in the list.
to move the cursor to the last target device in the list.
Chapter 3: Local Port Operation
to open the Main dialog box.
Print Screen
.
Insert
23