Gpu Power Cable Option - HP ProLiant DL360e Gen8 User Manual

CAUTION:
disconnect all power cords before removing or installing the PCI riser cage.
CAUTION:
all expansion slots have either an expansion slot cover or an expansion board installed.
To install the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 18).
o
Remove the access panel (on page 19).
4.
Remove the PCI riser cage (on page 20).
5.
Identify the expansion slot compatible with the new option, and then remove the cover opposite that
6.
slot.
Install the expansion board.
7.
Install the PCI riser cage (on page 21).
8.
IMPORTANT:
Connect all necessary internal cabling to the expansion board. For more information on these cabling
9.
requirements, see the documentation that ships with the option.
Install the access panel (on page 20).
10.
Install the server into the rack
11.
Connect all necessary external cabling to the expansion board. For more information on these cabling
12.
requirements, see the documentation that ships with the option.
Power up the server (on page 17).
13.

GPU power cable option

Connect the GPU power cable option to support high-power GPUs.
To prevent damage to the server or expansion boards, power down the server, and
To prevent improper cooling and thermal damage, do not operate the server unless
The server does not power up if the PCI riser cage is not seated properly.
("Installing the server into the rack" on page 27).
Hardware options installation 62