Install The Access Panel; Remove The Pci Riser Cage - HP ProLiant DL360e Gen8 User Manual

Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 18).
o
Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the
4.
access panel.
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.

Install the access panel

Place the access panel on top of the server with the access panel latch open. Allow the panel to extend
1.
past the rear of the server by approximately 1.25 cm (0.5 inch).
Close the access panel latch. The access panel slides to a closed position.
2.
Use a T-15 Torx screwdriver to tighten the access panel latch screw.
3.

Remove the PCI riser cage

CAUTION:
disconnect all power cords before removing or installing the PCI riser cage.
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 18).
o
Remove the access panel (on page 19).
4.
Disconnect all cables connected to any existing expansion board.
5.
Lift the release tabs, and then rotate them 180° counterclockwise.
6.
To prevent damage to the server or expansion boards, power down the server, and
Operations 20