Operating Environment Precautions; Application Precautions - Omron PRT1-SCU11 Operation Manual

Operating Environment Precautions

4

Operating Environment Precautions

!Caution Do not operate the Unit in the following places:
!Caution The operating environment of the PROFIBUS-DP Gateway to Host Link/Com-
5

Application Precautions

!WARNING
!Caution Failure to abide by the following precautions could lead to faulty operation of
• Locations subject to direct sunlight.
• Locations subject to temperatures or humidities outside the range speci-
fied in the specifications.
• Locations subject to condensation as the result of severe changes in tem-
perature.
• Locations subject to corrosive or flammable gases.
• Locations subject to dust (especially iron dust) or salt.
• Locations subject to exposure to water, oil, or chemicals.
• Locations subject to shock or vibration.
Provide proper shielding when installing in the following locations:
• Locations subject to static electricity or other sources of noise.
• Locations subject to strong electromagnetic fields.
• Locations subject to possible exposure to radiation.
• Locations near to power supply lines.
poway-F can have a large effect on the longevity and reliability of the system.
Unsuitable operating environments can lead to malfunction, failure and other
unforeseeable problems with the system. Ensure that the operating environ-
ment is within the specified conditions at installation time and remains that
way during the life of the system. Follow all installation instructions and pre-
cautions provided in the operation manuals.
Observe the following precautions when using the PROFIBUS-DP Gateway
to Host Link/Compoway-F.
Failure to abide by the following precautions could lead to serious or possibly
fatal injury. Always heed these precautions.
• Always connect to a class-3 ground (100
Units.
the Unit or the system or could damage the Unit or Temperature Controllers
and R88A-MCW151-E. Always heed these precautions.
• Install double safety mechanisms to ensure safety against incorrect sig-
nals that may be produced by broken signal lines or momentary power
interruptions.
• When adding a new device to the network, make sure that the baud rate
is the same as other nodes.
Ω
or less) when installing the
4
xiii