Appendix; Safety Guidelines; Important Notice Concerning Power Cord Selection - Siemens CMTC1515 User Manual

10

Appendix

10.1

Safety Guidelines

10.2

Important notice concerning power cord selection

Siemens Building Technologies
Fire & Security Products
This device must be operated with the original power supply, part number: LI
WARNING
SHIN 0219B1280 or LINEARITY LAD10PFKB6.
The socket outlet should be installed near the equipment and should be easily
CAUTION
accessible.
Use a power cable that is properly grounded. Always use the appropriate AC
cord that is certified for the individual country. Some examples are listed below:
CAUTION USA...........UL
Canada......CSA
Germany.....DE
The power cord set for this unit has been enclosed and has been selected
according to the country of destination. It must be used to prevent electric shock.
Use the following guidelines if it is necessary to replace the original cord set, or if
the cord set is not enclosed.
The female receptacle of the cord set must meet IEC-60320 requirements and may
look like this (Figure A1 below):
Figure A1
FOR THE UNITED STATES AND CANADA
In the United States and Canada the male plug is a NEMA5-15 style (Figure A2),
UL Listed, and CSA Labeled. For units which are mounted on a desk or table, SVT
or SJT type cord sets may be used. For units which sit on the floor, only SJT type
cord sets may be used. The cord set must be selected according to the current
rating for your unit. Please consult the table below for the selection criteria for
power cords used in the United States and Canada.
Code Type Size of Conductors in Cord
SJT
SVT
Switzerland.......SEV
Britain..............BASE/BS
Japan...............Electric Appliance Control Act.
Figure A2
Maximum Current Rating of Unit
18 AWG
16 AWG
14 AWG
18 AWG
17 AWG
Appendix
10 Amps
12 Amps
12 Amps
10 Amps
12 Amps
21
1715 Monitor UG_EN.doc
06.2004