Appendix; Setting Parameters For Lcd Monitors Of 15 Khz And Above, Example: Wf 470 System - Siemens SCD 1815-E Operating Instruction

5. Appendix

5.1. Setting parameters for LCD monitors of 15 kHz and above,
example: WF 470 system
Switch positions of BNC input sockets:
A1 = ON, A2 = OFF, A3 = ON, A4 = ON, A5 = ON
- Select "Utilities" menu using menu key.
- Select "Installation of RGB mode" using Enter key.
- Press key – the submenu is displayed.
Visible H-pixels = 512
- Use the keys to set the correct value.
- Press Enter key to confirm the set value.
Visible V-lines = 256
- Use the keys to set the correct value.
- Press Enter key to confirm the set value.
Total H-pixels = 768
- Use the keys to set the correct value.
- Press Enter key to confirm the set value.
Start H-pixels = 188
- Use the keys to set the correct value.
- Press Enter key to confirm the set value.
Start V-lines = 39
- Use the keys to set the correct value.
- Press Enter key to confirm the set value.
At the end of the adjustment procedure:
- Press key –
an automatic adjustment is carried out using the entered parameters.
Note
It may be necessary to improve the picture using "Frequency" and "Phase".
If the picture is offset, adjust using "Horizontal position" or "Vertical position".
LCD-Monitor SCD 1815-E page 51 / 52
Operating Instruction
DOC-Nr.: B30055DE6.doc