Fellowes Voyager 125 Instructions Manual page 7

STEPS TO LAMINATE - MANUAL OPERATION
On start menu, select "Manual"
operation within 5 seconds of
switching machine on.
The 'Ready' screen will show
when warm-up is complete and
two short beeps indicate that
machine is ready and user can
insert pouch.
MAINTENANCE - Easy-Access
The Voyager laminator can be manually opened via the LCD user interface. Please note that the power supply needs to be ON
and the laminator needs to be SWITCHED ON to open.
Select 'Open' in the
start-up menu using the
navigating buttons and
confirm the selection with
the 'OK' button.
Open the cover with
both hands. When the
laminator is opened,
power to internal
parts is isolated so
that the user is not
in danger of electric
shock.
To return to the "Home"
Menu at any stage, press
the "Left/back" key on the
navigation buttons.
Place the pouch, sealed edge first,
into the pouch / document entry.
Keep the pouch straight and use the
edge guide to center it.
The machine might
need to cool down if
it has already been
laminating, this can
take up to 30 minutes.
For further maintenance,
the internal mechanism
can be released by
experienced users. Pull
the cam levers forward
to release the mechanism
and lift it up.
Select pouch thickness
with navigation buttons as
required. Confirm selection
with "OK" button.
Upon exit, the laminated pouch is
hot and soft. Remove the pouch
immediately. Place pouch onto a flat
surface to cool. This helps prevent
any jamming.
The "open" LCD screen
will show and a beep will
sound when the laminator
is ready to be opened.
To clean residue off the
laminator mechanism,
please only use
Fellowes Laminator
wipes (item No #
57037). Do not use
sharp objects to clean
laminator.
The warm-up screen will
show until operating
temperature is reached.
Now move the lever
on each side of the
machine backwards to
open the top cover.
Please remember to
re-secure the mecha-
nism with the cam
levers again before
closing the cover.
7