Table of Contents
Advertisement
Site Selection and Preparation
2.
For ease of electrical hook
up you may wish to locate
the fireplace near an existing
outlet (refer to noTE 1).
3.
Store the fireplace in a safe
dry and dust free location.
Operation
Electric Fireplace Manual
Control
The manual controls for the
fireplace are located in the upper
right hand corner (Figure 1).
A. On/Off Switch
Supplies power to the 3 position
manual control switch.
B. 3 Position Switch
Remote (left position): The
unit is operated with the remote
control.
Flame (center position): The
flame effect is turned ON.
Flame & Heat (right position):
The flame effect and heater are
turned on simultaneously. When
the manual control is in the Flame
& Heat position the heater does
8
!
NOTE: The dimensions of
the fireplace are 44 inches
(1118 mm) wide x 34 inches
(883 mm) high x 11 5/8 inches
(295 mm) deep. The fireplace
does not require any additional
venting.
Figure 1
C
not run on the remote operated
thermostat.
!
NOTE: When the 3-position
switch is in the Flame and
Flame & Heat positions, the
fireplace unit will not operate
with the remote control.
C. Initialization Button
used to synchronize the remote
control.
Resetting The
B
a
www.dimplex.com
Advertisement
Table of Contents
